Hardware Store
New At Our Store
             We now stock a selection of high performance car care products by Mothers.

Mothers outstanding line of superior car care products will clean and protect every surface of your vehicle... glass, convertible tops, leather care, vinyl care, plastics, thermoplastics, polycarbonate, paint, chrome, and rubber.


Mothers products are specialized to tackle specific problems, however the vast majority of these products have been designed with ease of use in mind. The average consumer will be as satisfied as the ultra-enthusiast.

Whatever your interests, detailing problems, or level of expertise, you are sure to find that Mothers car care line will exceed your expectations. Highly respected and admired in the detailing industry, Mothers™ has earned much acclaim over the years for its performance standard and results.
Mothers products are specialized to tackle specific problems, however the vast majority of these products have been designed with ease of use in mind. The average consumer will be as satisfied as the ultra-enthusiast.

Whatever your interests, detailing problems, or level of expertise, you are sure
to find that Mothers car care line will exceed your expectations. Highly respected and admired in the detailing industry, Mothers™ has earned much acclaim over the years for its performance standard
and results.
  We now stock contractor quality driveway crack and joint filler PLI-STIX®.

PLI-STIX® is permanent because it is applied with heat. All you need is a simple hand held torch. It bonds to the sidewalls of the crack. Cracks open up because they expand and contract with freeze/thaw cycles - but PLI-STIX® will expand and contract right along with mother nature!

Apply it in 3 easy steps.

Clean the crack
Before applying the product, it is important to thoroughly clean out the crack and remove any loose debris. Rinsing the crack and allowing it to dry will give you the best results.

Install Filler 
Now you are ready to install the PLI-STIX®. Simply place the PLI-STIX® into the crack (do not remove the plastic wrap from the PLI-STIX®). The PLI-STIX® must be inside the crack so we recommend pushing the PLI-STIX® into the crack using a screwdriver. (*Note: If the crack is not as wide as the ½" PLI-STIX®, we recommend stretching the PLI-STIX® out...you can leave it in the sun for a while to make it easier to stretch. You can also splice it with a razor blade).

Melt it
Once it's in simply light your torch (we recommend a Bernzomatic hand-held torch) and apply direct flame to the PLI-STIX® until it liquifies - this should take about 20 - 30 seconds. Allow the PLI-STIX® to set up for 20 minutes. PLI-STIX® can be sealed over once properly set up.

Do not apply in wet cracks or where frost, snow or ice is present. Do not apply if the ground temperature is below 40 degrees.

See more at www.latexite.com.

Website Builder